Instances configuration to use password-based authentication for Kyvos deployment

Applies to: Kyvos Enterprise Kyvos Cloud (SaaS on AWS) Kyvos AWS Marketplace

Kyvos Azure Marketplace Kyvos GCP Marketplace Kyvos Single Node Installation (Kyvos SNI)

To use password-based authentication for instances when deploying the Kyvos cluster using the Wizard-based method, you need to provide certain permission to the deployment user. This section provides details of permissions required for all the cloud platforms.

If you are using a Linux user other than Kyvos, then you might need to give some permissions to this user.

Important

If you want to use an AD/LDAP user for deployment, ensure that all the permissions mentioned in this section are available for the user.

In the following commands, $user represents the Linux user deploying the cluster. Replace it according to your requirement.

Execute the following commands from the root user.

Note

You MUST perform the following steps on ALL the instances that you want to use for Kyvos deployment with Password authentication.
Creating and adding a node is not supported for a password-based cluster deployed via the wizard. To enable the create or add node functionality in Kyvos Manager, ensure that you use the appropriate AMI that supports password-based authentication for the deployed cluster, rather than a private key (PEM file) based AMI.

HTTP Status 429 – Too Many Requests

Instances configuration to use password-based authentication for Kyvos deployment

HTTP Status 429 – Too Many Requests